This is default featured slide 1 title
This is default featured slide 2 title
This is default featured slide 3 title
This is default featured slide 4 title
This is default featured slide 5 title
 

Garage Floor Epoxy System

The most probable reason for failure is improper surface preparation. The floor must be completely clean and stripped of all other coatings. Any stains or foreign substances (oil, grease, paint, etc.) will prevent adequate bonding between the concrete and epoxy, resulting in chipping and flaking. Most contractors will apply a coat of sealer to a garage floor after installation. It can take several years for the sealer to wear off completely. This sealer must be removed for epoxy to last. Although acid etching is an important step, it will not remove sealer and most stains. Etching will only open up the pores of bare concrete, therefore you must do all cleaning and stripping before etching with acid.

Before purchasing a garage floor epoxy system, you need to first decide if your floor is right for it. If it sweats often or there are areas that are constantly wet, then forget about it. Be sure that you are willing to take the time to prep the floor properly, as this is the most critical part. It also helps to put one or two coats of clear concrete sealer on top to serve as a wear coat. Water based acrylic sealers are ideal for indoor residential use. Despite any bad reviews you’ve heard about the do-it-yourself garage floor epoxy system, it can be a successful project if it’s done correctly.